britax graphene compact baby car seat

Recommended  – The Britax Graphene is an easy to use (loosen and tightening the harness) ; and easy adjust harness in small increments. The Britax Graphene comes with both; isofix and seat belt installation options; with three recline positions; one for rear facing , one upright forward facing and one recline forward facing position.

Thermo fabric

The Thermo fabric s a wicking fabric (Thermo5 ) designed to draw moisture away from your child, keeping them cooler. The Thermo fabric is also easier to clean.

Britax Graphene Isofix

In 1997 britax along with Volkwagon created the Isofix system; designed to help parents install their child restraints easier. With over 20 years of creating carseats the Isofix on the Britax Graphene is easy to attach, and tension and provides a solid installation. When the Isofix cannot be used the isofix connections tuck easily in a compartment and are hidden.

Britax Graphene Recline

THe Britax Graphene has three recline positions; one for rear facing and two for forward facing. The forward facing recline can be achieved by squeezing the pedestal at the rear and moving to the required position. The rear facing recline requires squeezing the pedestal at the rear and moving to the required position.

Note : The forward facing recline positions is only a slight recline in some cars where there is a seperation between the cars seat. When you need a better forward recline then I suggest the Britax Millenia.

Safer Harness design

The Britax Graphene car seat like all Britax seats; has a harness increment of 15 mm; whereas other manufacturers such as maxi cosi have a 30 mm adjustment and infa secure have roughly a 40mm adjustment. This smaller harness adjustment means the harness is in the optimal position and closer to your childs shoulders; keeping them safer.

An additional benefit of the smaller increments is that there is less chance your child will get their arms out of the harness.

Britax Graphene Harness Adjustmnet

Adjusting the harness position on the Graphene is not as easy as the Millenia. In rear facing mode; the easiest way to adjust the harness positions; is using the blue lever at the rear of the seat. In forward facing mode, you must press down on a “PUSH” label and then at the same time lift the headrest up. This motion can be difficult and made harder for people with arthritis and long nails.

Harness Loosening

In early models of the Graphene, one of the biggest problems was that when you want toloosen the harness you must pull both straps together. When you try to pull one harness strap to loosen the harness; the spreader plate gets caught and tangled with the upper tensioning bar; such that when you tighten the harness next time one harness strap will be longer than the other….

Easy Cleaning

Unlike many other car seats out there, it is possible to easily take off the Graphene covers, without un-installing the graphene, should they get messy.

Britax Installation

Installation of the Britax Graphene is easy; when your car has isofix points to use. The installation using the seat belt is somewhat harder, requiring a locking clipor gated buckle. A possible easier solution is to ask the baby store for a “Lockie”. The lockie will replace the gated buckle and is used on the buckle side.

. When you have doubts about your ability to install your child restraint fitting call in a professional baby seat installation expert